Installing A Hard Drive Behind The Power Supply - Mitsubishi Apricot LS Series Owner's Handbook Manual

C h a s s i s a n d C o m p o n e n t s
2/18 LS700 HANDBOOK
1. Observe the precautions in 'Before You Begin', at the
beginning of this chapter.
2. Remove the non-access side panel.
3. Remove the power supply (see later in this chapter).
4. Remove the drive from its protective wrapper and place
it on an antistatic surface.
5. Set any jumpers, switches, or terminating resistors on
the drive according to the manufacturer's instructions.
6. Slide the drive into position. Line the screw holes on
the drive up with the holes on the chassis. (See Figure
15).
7. Insert and tighten three screws of the appropriate type
and length (not supplied).
8. Attach the power cable and the data cable to the drive.
9. Reinstall the power supply.
Figure 15. Installing a Hard Drive Behind the
Power Supply
A