Installing A Hard Drive In The Carrier - Mitsubishi Apricot LS Series Owner's Handbook Manual

Removing a Hard Drive from the Diskette Drive Carrier
Installing a Hard Drive Behind the Power Supply
Figure 14. Installing a Hard Drive in the Carrier
1. Observe the precautions in 'Before You Begin', at the
beginning of this chapter.
2. Remove the floppy diskette drive carrier.
3. Remove the three screws holding the drive to the
carrier.
4. Slide the drive out of the carrier and place it on an
antistatic surface.
5. Install the drive carrier back into the chassis.
WARNING
This procedure should be done only by qualified technical
personnel. Unplug the computer before doing the procedures
described here.
C h a s s i s a n d C o m p o n e n t s
A
LS700 HANDBOOK 2/17