Installing The Drive - Mitsubishi Apricot MS Series Owner's Handbook Manual

Installing the drive

A
A
B
B
B B
1. Turn off the computer and unplug all power
cords.
2. If there is a diskette in the diskette drive, remove
it.
3. Take suitable anti-static precautions and remove
the system unit cover. For more information see
"Anti-static precautions" in the Safety &
Regulatory Notices at the start of this manual.
4. Disconnect the power and signal (ribbon) cables
from the rear of the diskette drive. Take careful
note of how they are fitted.
5. Loosen the two screws labelled (A) in the
diagram. Slide the diskette drive assembly
towards the rear of the system and lift it out.
6. Disconnect the power, signal and CD audio
cables from the rear of the CD-ROM drive.
Disconnect the power and signal cables from the
rear of the existing (master) hard disk drive
(HDD). Take careful note of how and where
they are fitted.
H a r d D i s k U p g r a d e s
OWNER'S HANDBOOK
6 / 3