Lldp; Reset; Resetting To Factory Default (Factory Setting); Resetting Settings Except Private Settings - Panasonic KX-UTG200 Setup Manual

1.1.6.3 LLDP

The LLDP (Link Layer Discovery Protocol) is a vendor-neutral link layer protocol used by network devices for
advertising their identity, capabilities, and neighbors in a LAN. It also used for getting the VLAN information
from the switch in the network environment the unit is connected to.

1.2 Reset

1.2.1 Reset

1.2.1.1 Resetting to Factory Default (Factory Setting)

Performing Factory Setting from the phone user interface resets all settings in the unit to their factory defaults.
This type of initialization also deletes all other data on the unit, such as the call logs and the phonebook.
To perform this initialization, follow the procedure below:
1.
On the Home screen, select
2.
If you are not logged in as the Admin level user, select "Change Level" and enter the user ID and password
for the Admin level user, and then press [ENTER].
•
Settings cannot be performed if you are logged in as the User level user.
•
Settings can only be performed if you are logged in an as the Admin level user and
"DISABLE_FACTORY_RESET_FROM_ADMIN" (DISABLE_FACTORY_RESET_FROM_ADMIN
(Page 295)) is enabled.
3.
Press [#][1][3][6].
4.
Enter the admin password, and then press [ENTER].
5.
Select
Yes
Notice
•
After performing Factory Setting, the unit will restart automatically. To avoid problems, it is
recommended that you save your settings before performing Factory Setting.

1.2.1.2 Resetting Settings Except Private Settings

Executing "Exclude Private Settings" resets all settings except for private settings. Private settings include
ringtone volume, brightness, phonebook, and call history.
To perform this initialization, follow the procedure below:
1.
On the Home screen, select
2.
Select "Reset", and then press [ENTER].
3.
Select "Reset Excluding Private Settings", and then press [ENTER].
4.
Select Yes

1.2.1.3 Resetting Settings Except Network Settings

Executing "Reset Excluding Network Settings" resets all settings except for network settings. Private settings
and Bluetooth settings (KX-UTG300 only) are reset in this case. Network settings include IPv4, IPv6, LLDP
Settings, CDP Settings, VLAN Settings, Speed/Duplex, and Port Mirroring phone user interface settings, and
RTP Packet QoS (DSCP) and RTCP Packet QoS (DSCP) web user interface settings.
To perform this initialization, follow the procedure below:
Document Version 2015-01
.
.
.
.
1.2.1 Reset
Administrator Guide 37