Panasonic KX-UTG200 Setup Manual page 354

5.10.1 Log Settings - General
Value Range
Default Value
REFER_TO_IP_FMT_ON_CONF
Value Format
Description
Value Range
Default Value
SIP_ADD_ROUTE
Value Format
Description
Value Range
Default Value
5.10 Diagnostic Settings
5.10.1 Log Settings - General
LOG_TERMINAL_DISP_ENABLE
Value Format
Description
Value Range
Default Value
354 Administrator Guide
•
Y/Yes (If the server's address is FQDN, use the translated IP
address in Refer-To header to send the REFER packet)
•
N/No (Use the original server setting (Refer-To header may bring
the FQDN).)
N
Boolean
Specifies whether to use the server's translated IP address in Refer-To
header of the REFER packet when having a conference call.
•
Y/Yes (If the server's address is FQDN, the translated IP address
is used in Refer-To header to send the REFER packet.)
•
N/No (Use the original server setting (Refer-To header may bring
the FQDN))
Y
Boolean
Specifies whether to add a route header if an outbound proxy is
configured.
•
Y/Yes (Add a route header)
•
N/No (Do not add a route header)
Y
Boolean
Specifies whether to display the log on terminal, console or SSH.
•
Y/Yes (Display the log on terminal)
•
N/No (Do not display the log on terminal)
Y
Document Version 2015-01