Loading A File From The Usb Flash Drive - Yamaha CL5 Reference Manual

Loading a file from the USB flash drive

Follow the steps below to load CL settings file (extension .CLF) from the USB flash drive into the CL
series console.
You can use the same procedure to load the following files as well as setting files.
Extension Type
.CLF ALL CL console internal setting file
.CLU KEY CL console user authentication key
.XML XML XML file for displaying Help
.TXT TEXT Text file for displaying Help
Image file for display in the CONSOLE LOCK screen (256 or more
.BMP BMP
colors, uncompressed bitmap format)
NOTICE
Some data may contain settings that will cause the console to output signals immediately after
the data is loaded. Therefore, before loading data, turn off the power to the equipment connected
to the CL series console and/or lower the volume of such equipment so that there will not be a
problem even if a signal is output from the CL console.
1.
In the Function Access Area, press the SETUP button to access the SETUP screen.
2.
Press the SAVE/LOAD button to access the SAVE/LOAD popup window.
3.
To select the file that you want to load, press the name of the desired file in the file
list, or rotate the corresponding multifunction knob on the panel.
The highlighted line in the file list indicates the file that is selected for operations.
4.
Press the LOAD button. A confirmation dialog box will appear.
Contents of file
5.
Press the OK button to begin loading the file.
When the file has finished being loaded, the popup window showing the loading progress and the
type of data will close. If you cancel this procedure while it is in progress, data up to the
cancellation point will still be loaded.
Some setting data may not be loaded, depending on the USER LEVEL setting during the load
operation.
Editing the files saved on the USB flash drive
This section explains how to perform editing operations such as sorting the files and directories on the
USB flash drive, editing the file names or comments, copying, and pasting.
■ File editing
1.
In the Function Access Area, press the SETUP button to access the SETUP screen.
2.
Press the SAVE/LOAD button to access the SAVE/LOAD popup window.
The list will show the files and sub-directories that have been saved.
5 1 2 3 4
7
8 9 0 C
1
COPY button
Copies a file into buffer memory (a temporary holding area).
2
PASTE button
Pastes the file from buffer memory.
3
DELETE button
Deletes the selected file.
4
MAKE DIR button
Creates a new directory.
173
User settings (Security)
6
A B
Reference Manual