Sending Signals From Mix Channels And Stereo/Mono Channels To Matrix Buses - Yamaha CL5 Reference Manual

Sending signals from MIX channels and STEREO/
MONO channels to MATRIX buses
This section explains how to send a signal from a MIX or STEREO/MONO channel to MATRIX buses
1–8. You can do this in either of the following two ways.
■ Using the SELECTED CHANNEL section
With this method, you use the knobs in the SELECTED CHANNEL section to adjust the send levels to
the MATRIX buses. This method allows you to simultaneously control signals sent from a specific MIX,
STEREO (L/R), or MONO (C) channel to all MATRIX buses.
■ Using the Centralogic section
With this method, you use the multifunction knobs in the Centralogic section to adjust the send levels
to the MATRIX buses. This method allows you to simultaneously control signals sent from up to eight
MIX, STEREO (L/R), or MONO (C) channels to a specific MATRIX bus.
Using the SELECTED CHANNEL section
Use the knobs in the SELECTED CHANNEL section to adjust the send level of signals sent from the
desired MIX, STEREO (L/R) or MONO (C) channel to all MATRIX buses.
1.
Make sure that an output port is assigned to the MATRIX bus to which you want
to send signals, and that an external device is connected.
2.
Using the Bank Select keys in the Centralogic section, assign the desired MIX
channels or the STEREO/MONO channels to the Centralogic section.
3.
Use the [SEL] keys in the Centralogic section to select the channels that will send
signals to the MATRIX buses.
You can also use the [SEL] key in the MASTER section to directly select the STEREO/MONO
channels.
4.
Press a knob in the SELECTED CHANNEL section to access the SELECTED CHANNEL
VIEW screen.
5.
Make sure that the TO MATRIX SEND ON/OFF button is turned on for the send-
destination MATRIX bus.
If this button is off, press the button on screen to turn it on.
6.
In the SELECTED CHANNEL section, use the MIX/MATRIX SEND LEVEL knobs to
adjust the send levels to the MATRIX buses.
NOTE
If you want to monitor the signal being sent to a specific MATRIX bus, use the Bank Select keys
in the Centralogic section to access the corresponding MIX/MATRIX channel, and then press the
appropriate [CUE] key in the Centralogic section.
7.
Use the Bank Select keys and the [SEL] keys in the Centralogic section to switch
channels, and adjust the send level from other channels to the MATRIX buses in
the same way.
51
Output channels
Reference Manual