Yamaha CL5 Reference Manual page 101

4
CUE OUTPUT button
Switches the cue output on or off.
5
CLEAR CUE button
Cancels all cue selections simultaneously. If MIX CUE mode has been selected, all selected
channels will be cleared.
2.
Press the CUE popup display button or the INPUT/DCA/OUTPUT CUE field to open
the CUE popup window.
The popup window includes the following items.
1 2 4 7
3 5 6
1
CUE MODE buttons
Select one of the following two cue modes:
• MIX CUE
All selected channels will be mixed and auditioned.
• LAST CUE
Only the most recently selected channel will be auditioned.
■ INPUT CUE field
This field enables you to make settings related to the input channel cue.
2
Cue point select button
Sets the cue point to PFL (immediately before fader), AFL (immediately after fader), or POST
PAN (immediately after PAN).
NOTE
Be aware that if you turn on the POST PAN button, you will be unable to monitor signals sent to
the MONO bus from an input channel in LCR mode.
3
PFL TRIM knob
Indicates the monitor levels when PFL is selected. Use the multifunction knob to adjust the level.
A
B
9
0
8
■ DCA CUE section
This section enables you to make settings related to DCA cue.
4
Cue point select button
Sets the cue point for the DCA group to PRE PAN (immediately before PAN) or POST PAN
(immediately after PAN).
5
DCA TRIM knob
Indicates the monitor level of cue signals from a DCA group. Use the multifunction knob to adjust
the level.
6
UNITY button
Turn on this button to monitor signals at the same volume level that was obtained when the
master level for each DCA group was set to 0 dB (unity gain).
■ OUTPUT CUE section
This section enables you to make settings related to output channel cue.
7
Cue point select button
Sets the cue point for the output channel to PFL (immediately before fader) or AFL (immediately
after fader).
8
PFL TRIM knob
Indicates the monitor levels when PFL is selected. Press this knob so that you will be able to use
the multifunction knob to adjust the level.
9
ACTIVE CUE indicator
Lights to indicate the type of cue currently being monitored (input: blue, DCA: yellow, output:
orange).
0
CLEAR CUE button
Press this button to clear all cue selections simultaneously.
A
Meter section
Indicates the output level of the L/R channel cue signal. Press the CUE OUT PATCH button below
the meter to open the PORT SELECT popup window, in which you can select an output port to
patch to the cue output L/R/C channels.
B
CUE OUTPUT button
Switches cue output on or off.
101
Monitor and Cue functions
Reference Manual