Setup - Yamaha CL5 Reference Manual

4.
To specify the port that will be used to transmit or receive each type of MIDI
message, press the transmit (Tx) or receive (Rx) port select popup button.
The MIDI SETUP popup window for selecting the port will appear. Operations in this window
are the same for both transmission (Tx) and reception (Rx). This window includes the following
items.
1 2
1
TERMINAL field
Enables you to select the port that will transmit or receive MIDI messages.
You can choose from the following items.
NONE No port will be used.
MIDI MIDI IN (Rx) and OUT (Tx) connectors on the rear panel
SLOT1 A card that supports serial transmission and is installed in Slot 1 on the rear panel
2
PORT NO. field
If you select SLOT 1 in the TERMINAL field, choose port number 1–8 in this field. (The number
of available ports will vary depending on the card that is installed.) The currently-available card
is valid only for port 1.
5.
Specify the type of port and the port number.
Use the / buttons to select an item. Press the OK button to confirm the selected port and
close the MIDI SETUP popup window.
NOTE
Alternatively, you can select a port by pressing the desired port name in the field, or by pressing
the field to highlight it and then rotating one of the multifunction knobs to select the port.
6.
To specify the channel on which MIDI messages will be transmitted or received,
press the channel select popup button.
The MIDI SETUP popup window for selecting the channel will appear. Operations in this
window are the same for both transmission (Tx) and reception (Rx). This window includes the
following items.
1
1
CH field
Enables you to select CH1–CH16 as the channel that will transmit or receive MIDI messages.
7.
Select the channel.
Use the / buttons to select an item. Press the OK button to confirm the selected channel and
close the MIDI SETUP popup window.
NOTE
• Alternatively, you can select the channel by pressing the desired channel in the field or by rotating
one of the multifunction knobs.
• When transmitting or receiving Parameter Changes, the channel number you specify here is used
as the device number (a number that identifies the transmitting or receiving unit).
8.
Turn transmission/reception on or off for each MIDI message.
NOTE
• For details on using Program Change messages, refer to "Using Program Changes to recall
scenes and library items," below.
• For details on using Control Change messages, refer to
parameters" on page 150.
146
MIDI
"Using Control Changes to control
Reference Manual