Linking The Desired Input Channels - Yamaha CL5 Reference Manual

Linking the desired input channels

This section explains how to link specific parameters of input channels.
NOTE
Channel link settings are saved as part of the scene.
1.
In the Function Access Area, press the CH JOB
button.
2.
Press the CH LINK button to open the CH LINK
MODE popup window.
In this popup window you can view the channels that are
linked and specify the parameters that will be linked. The
window includes the following items.
NOTE
You can also access this window by simultaneously
pressing and then releasing the [SEL] keys of two or more
channels that will be linked.
1
2
3
CH LINK button
3.
70
1
Channel display field
When you create a link group, the corresponding channels will be highlighted. If there are two or
more link groups, each group is shown in a different color.
NOTE
Left and right of the ST IN channel are always linked.
2
LINK PARAMETERS field
Use the buttons in this field to select the parameters that you want to link. You can do this
independently for each link group.
3
SEND PARAMETERS field
If you have turned on the MIX ON, MIX SEND, MATRIX ON, or MATRIX send buttons in the
LINK PARAMETER field, use the buttons in this field to specify the send-destination bus(es).
NOTE
In the case of the CL3/CL1, faders that do not exist on those models will not be shown.
Use the buttons in the LINK PARAMETERS field to select the parameter(s) that will
be linked (multiple selections are allowed).
The table below lists the parameters you can select in the LINK PARAMETERS field.
HA Head amp settings
HPF HPF settings
DIGITAL GAIN Digital gain settings
EQ EQ settings
DYNAMICS 1, 2
Dynamics 1 and 2 settings
INSERT Insert settings
DIRECT OUT Direct Out settings
MIX SEND Send levels of signals sent to MIX buses
MIX ON On/off status of signals sent to MIX buses
MATRIX SEND
Send levels of signals sent to MATRIX buses
MATRIX ON On/off status of signals sent to MATRIX buses
FADER Fader operations
DCA DCA group assignment
CH ON Channel on/off
MUTE
Mute group assignment
TO STEREO On/off status of signals sent to STEREO/MONO buses
DELAY Channel delay settings
NOTE
• If you link Dynamics 1 or 2 for two or more input channels, the parameter values will be linked,
but the key-in signals are not linked. For details about dynamics, see
page 55.
• If you turn on the EQ button or DYNAMICS 1/2 button, library recall operations will also be linked.
• The HA analog gain setting and the fader operation will be linked and will maintain the same
relative level difference between the channels.
Grouping and linking
"EQ and Dynamics" on
Reference Manual