Figure 47: Positioning The Sfp Or Sfp+ Handle In The Upright Position; Figure 48: Connecting A Fiber Optic Cable To An Sfp Or Sfp+ Transceiver - Allied Telesis AlliedWare Plus AT-x530-28GPXm Installation Manual

Chapter 8: Cabling the Networking Ports
98
7. Verify the position of the handle on the transceiver. If the transceiver is
in a top slot, the handle must be in the upright position, as shown in
Figure 47. If the transceiver is in a bottom slot, the handle must be in
the down position.
SFP Handle
Figure 47. Positioning the SFP or SFP+ Handle in the Upright Position
8. Connect the fiber optic cable to the transceiver, as shown in Figure 48.
The connector on the cable must fit snugly into the port, and the tab
must lock the connector into place.
Figure 48. Connecting a Fiber Optic Cable to an SFP or SFP+ Transceiver
9. Repeat this procedure to install additional transceivers.
2 5
2
5 G /
2 . 5 G
/ 1 G
/ 1 0 0
2 6
2
5 G /
2 . 5 G
/ 1 G
/ 1 0 0
S F P
+
2 7 /
S 1
1 0 G
/
1 G
2 5
S F P
+
2 7 /
S 1
2 6
1 0 G
/
1 G