Figure 50: Positioning The Sfp Or Sfp+ Handle In The Upright Position; Figure 51: Connecting A Fiber Optic Cable To An Sfp Or Sfp+ Transceiver - Allied Telesis AlliedWare Plus x530 Series Installation Manual

5. Verify the position of the handle on the transceiver. If the transceiver is
in a top port, the handle must be in the upright position, as shown in
Figure 50. If the transceiver is in a bottom port, the handle must be in
the down position.
SFP Handle
Figure 50. Positioning the SFP or SFP+ Handle in the Upright Position
6. Connect the fiber optic cable to the transceiver, as shown in Figure 51.
The connector on the cable must fit snugly into the port, and the tab
must lock the connector into place.
Figure 51. Connecting a Fiber Optic Cable to an SFP or SFP+ Transceiver
7. Repeat this procedure to install additional transceivers.
x530 Series Installation Guide for Stand-alone Switches
2 5
2
5 G /
2 . 5 G
/ 1 G
/ 1 0 0
2 6
2
5 G /
2 . 5 G
/ 1 G
/ 1 0 0
S F
P +
2 7 /
S 1
1 0 G
/
1 G
4576
2 5
S F
P +
2 7 /
S 1
2 6
1 0 G
/
1 G
4577
103