Conference Control Through Remote Control, Web Page, And Pc Console - Zte ZXV10 T700 User Manual

ZXV10 T700 Operation Guide
Operation
Configure terminal name and system
time
Set Video Input and output
Select a video source
Conference
1.2 Conference Control Through Remote Control, Web
Page, and PC Console
Currently, the ZXV10 T700 terminal supports three conference control modes, that is, GUI
on the remote control, Web page, and PC console. The following table lists the typical
application scenario of each mode.
Table 1-1 Typical Application Scenario of Conference Control Mode
Operation
Daily Configuration and Modification
Conference Control
Conference Initiation
Caution
If the remote control is not sensitive enough, check whether the battery in the remote
control is outdated.
Daily Configuration and Modification
You can perform daily configuration for the ZXV10 T700 terminal through the following two
modes: GUI on the remote control and Web page.
l
Use the direction keys on the remote control to enter the configuration page, and then
configure and modify the required parameters.
l
Visit http://IP address of the terminal, and then configure and modify the required
parameters.
Conference Control
You can perform conference control over the ZXV10 T700 terminal through the following
two modes: GUI on the remote control and PC console.
SJ-20100910163147-001|2010-11-23(R1.1)
Refer to
1.3 Configuring Basic Information for a Terminal
2.4.2 Video Input Settings
2.4.3 Video Output Settings
2.4.1 Switching Video Source
1.5 Calling for Conference Quickly
GUI on Remote
Control
√
√
√
1-2
ZTE Proprietary and Confidential
Web Page PC Console
√ -
- √
√ √