Validating Settings; Calling For Conference Quickly - Zte ZXV10 T700 User Manual

ZXV10 T700 Operation Guide
2. Select the GK type, enter the IP address of the GK, and set the GK port number
to 1719 according to the actual administrator configuration.
3. Contact the ZXMS80 system administrator and check the terminal number.
The terminal number is unique inside the network and based on which the GK
implements call addressing.
4. Save the settings and exit.

1.4 Validating Settings

Prerequisites
Terminal configuration can be modified only when the terminals are idle (not in a
conference).
Context
After you modify terminal configuration, do as follows to save and make the settings take
effect.
Steps
• Do as follows to modify terminal configuration by using the remote control:
1. After terminal information is modified, press the Return key on the remote control.
A confirmation dialog box is displayed.
2. Press the OK key on the remote control to confirm modification.
• To modify terminal configuration on the Web page, click OK at the lower part of the
page.

1.5 Calling for Conference Quickly

Prerequisites
The terminals are deployed and connected by using cables, and the basic settings for the
terminals are complete. However, the conference connection is not established.
Context
The following describes how to call a terminal or an MCU directly. For information on how
to call a terminal from the address book, refer to the chapters related to the address book.
Steps
1. On the main menu of the terminal, move the cursor to the Call column by using the
remote control. Alternatively, log in to the Web page and choose Call Control >
Call/Hangup to display the Call page.
2. The following table describes the related parameters.
SJ-20100910163147-001|2010-11-23(R1.1)
1-4
ZTE Proprietary and Confidential