Zte ZXV10 T700 User Manual page 20

ZXV10 T700 Operation Guide
Figure 2-3 Input Configuration Interface 2
5. Refer to the following table to configure the parameters displayed in the above figure.
In this Version, Parameters of Input Configuration Interface of inner camera is
noneffective.
Item
Enable Interface
Type
Select Image
Work Mode
Resolution
Serial Port
Control Protocol
SJ-20100910163147-001|2010-11-23(R1.1)
Note
Description
Only after a port is enabled, it can be displayed on the interface for
selecting video source
For example, after port YCbPr is enabled, the port is available on the
interface when you select a video source
Selects the type of the video input device connected to the port
Selects an image for the accessed device according to its type
Selects a working mode for the accessed device
Auto: Indicates the automatic selection mode. Alternatively, you can
select the required mode from the drop-down list
Selects the exactly resolution according to your connected devices
The serial port is connected with the camera controlling cable to
implement camera control
If the camera of the terminal is used, the serial port is optional
One serial port must be bound to one video input port to implement
control over the camera
To enable the Infrared remote control function of the camera, the
configuration of the serial port must be consistent with that on the Local
Setup interface
Selects the control protocol for the accessed device
For a SONY camera, set this parameter to SONY
2-8
ZTE Proprietary and Confidential