Page 2
ZTE CORPORATION is prohibited. Additionally, the contents of this document are protected by contractual confidentiality obligations. All company, brand and product names are trade or service marks, or registered trade or service marks, of ZTE CORPORATION or of their respective owners.
Describes the typical, dual-video and peripheral connections of the 5, Device Connection ZXV10 T700. Describes how to turn on/off the ZXV10 T700, the safety regulation 6, Device Operation and operation method of ZXV10 T700. Describes the technical specifications of ZXV10 T700 and its 7, Technical Specifications interfaces.
Page 6
This manual uses the following typographical conventions: Typeface Meaning Indicates a potentially hazardous situation. Failure to comply can result in serious injury, equipment damage, or interruption of major Caution services. Provides additional information about a certain topic. Note SJ-20120814152402-001|2012-08-30 (R1.0) ZTE Proprietary and Confidential...
Introduction Terminal Introduction The ZXV10 T700 is one of the T-series conference terminals developed by ZTE Corporation. The integrated design of the camera and terminal makes installation easier. The terminal can be placed on a flat surface or mounted on wall. It is suitable for small and medium size business conferences.
Supports IP automatic speed control. Supports NAT / FW traversal technology. Components The ZXV10 T700 is composed of the terminal, infrared remote control, microphone, and camera. The ZXV10 T700 components are listed in the following table. Table 1-1 Components of ZXV10 T700...
The front panel of the ZXV10 T700 is shown in Figure 2-2. Figure 2-2 Front Panel of the ZXV10 T700 The ZXV10 T700 has one status indicator. It will be continuously lit when the power is on. SJ-20120814152402-001|2012-08-30 (R1.0) ZTE Proprietary and Confidential...
ZXV10 T700 Product Description Rear Panel The ZXV10 T700 has various interfaces on the rear panel, such as communication interfaces, audio interfaces, video interfaces and network interfaces. Figure 2-3 Interface of Rear Panel Note: The interface of rear panel identifier are as follows: ,White frame without filled area are for the input interface.
Chapter 3 Device Networking After the ZXV10 T700 terminal accesses IP network, it can start a point-to-point meeting with other terminals in the network without network configuration. But when terminals participate in different types of multipoint conference, the administrator needs to perform networking setting.
Single MCU Networking When the conference is held on video conferencing server MCU such as ZXMVC8900, ZXV10 M900, or ZXV10 M9000, the ZXV10 T700 can join in the conference as normal terminal. Take M900 for example, the networking is shown in Figure 3-2.
Chapter 3 Device Networking Multiple MCUs Networking In the conference held by more than one MCUs, the ZXV10 T700 can join in the conference as a normal terminal. Take M900 for example, the networking is shown in Figure 3-3. Figure 3-3 Multiple MCUs Cascading Networking SJ-20120814152402-001|2012-08-30 (R1.0)
Page 14
ZXV10 T700 Product Description This page intentionally left blank. SJ-20120814152402-001|2012-08-30 (R1.0) ZTE Proprietary and Confidential...
4. Cables are not damaged, stained, or broken. Position and Install ZXV10 T700 The ZXV10 T700 can be placed on any flat surface, TV, or wall by means of racks. On the flat surface: Place the ZXV10 T700 on the flat surface and reserve sufficient space for cable connection.
ZXV10 T700 Product Description Figure 4-2 Mount the rack on TV Place the ZXV10 T700 on the rack by inserting the ZXV10 T700 into the screw hole in the rack as shown in Figure 4-3. Figure 4-3 Place ZXV10 T700 in the rack 4.
3. Connect the mounting bracket with the wall-mounted bracket, tighten the screws. Figure 4-5. Figure 4-5 Assemble plate 4. Place the ZXV10 T700 on the rack by putting the screw hole into the screw at the steel of the plate. See Figure 4-6.
Page 18
Before cleaning, stop using the device, disconnect the power, and unplug all connected cables from the device. It takes at least 15s to reboot the ZXV10 T700. Use a soft cloth to clean. SJ-20120814152402-001|2012-08-30 (R1.0) ZTE Proprietary and Confidential...
Dual Video Connection....................5-2 Connection of Peripheral Devices................5-3 5.1 Typical Connection For a typical connection, users only need to connect the video, audio, network and power cables. Refer toFigure 5-1 for details. Figure 5-1 Typical Connection SJ-20120814152402-001|2012-08-30 (R1.0) ZTE Proprietary and Confidential...
Dual video means two video streams: the first video stream is the primary video and the second video stream is the secondary video. The ZXV10 T700 can transmit up to two input video steams at the same time and the ZXV10 T700 also supports up to two output video steams displayed at the same time.
The video can be displayed on a TV , or a projector , or you can also select both of them. The secondary video can be connected with either of a HD DVD player , HD camera , or a PC SJ-20120814152402-001|2012-08-30 (R1.0) ZTE Proprietary and Confidential...
Do not use the same power line with other high-power units and do not connect the ZXV10 T700 and other high-power units on the same AC power supply facilities. Ensure that the ZXV10 T700 is positioned horizontally in the rack and do not install in the environment with severe vibration.
Conference control System maintenance System diagnosis The ZXV10 T700 terminal supports three control modes: GUI on the remote control, Web page, and PC console. Through GUI on the remote control: refer to ZXV10 T700 Remote Control Operation Guide for more details.
Page 25
Chapter 6 Device Operation GUI on Remote Operation Web Page PC Console Control Place a call √ √ √ Conference control √ √ System maintenance √ √ System diagnosis √ √ √ SJ-20120814152402-001|2012-08-30 (R1.0) ZTE Proprietary and Confidential...
Page 26
ZXV10 T700 Product Description This page intentionally left blank. SJ-20120814152402-001|2012-08-30 (R1.0) ZTE Proprietary and Confidential...
N-ISDN as integrated services digital network has two standard interfaces: basic rate interface BRI and primary rate interface PRI. N-ISDN channel structure is divided into 2B + D and 30B + D. This networking is very flexible and with small communication SJ-20120814152402-001|2012-08-30 (R1.0) ZTE Proprietary and Confidential...
Page 32
ZXV10 T700 Product Description costs, the disadvantage is the low line switch rate and lower meeting rate, so it is more suitable for business users. ITU-T H.323 ITU-T H.323 is based on multimedia communication series which does not guarantee the QoS in packet-switched network.
E1, the DDN, ISDN, or a packet-switched network such as the IP networks. Select different types of videoconference terminals and MCU devices to connect the networks depending on the network access methods. SJ-20120814152402-001|2012-08-30 (R1.0) ZTE Proprietary and Confidential...
ZXV10 T700 Product Description Multipoint Control Unit, also known as the MCU, is the key equipment of the multi-point videoconference system which acts as a switch. It extracts the audio, video, data and other information from all the conference sites. After separating, MCU sends the...
It is easy to expand and manage. Each MCU is not equal in this networking structure and has a specific role. The lower-layer MCU is controlled and restricted by the upper-layer MCU. Most current videoconference systems work in this networking mode. SJ-20120814152402-001|2012-08-30 (R1.0) ZTE Proprietary and Confidential...
Page 36
ZXV10 T700 Product Description This page intentionally left blank. SJ-20120814152402-001|2012-08-30 (R1.0) ZTE Proprietary and Confidential...
B.1 Conference Room Maintenance Maintenance personnel of the conference room should check the working environment of the ZXV10 T700 terminal periodically. It is recommended to conduct the inspection focusing on the following items: Check the temperature in the conference room and make sure that it meets the operating requirement of the terminal.
ZXV10 T700 Product Description Check and confirm all cables are connected correctly and firmly as soon as possible once the terminal and its peripheral equipment are moved to another place. B.3 Test Maintenance Test maintenance refers to conducting an overall system test before using the terminal.
- Gateway ISDN - Integrated Services Digital Network - Local Area Network - Multipoint Controller - Multipoint Control Unit - Multipoint Processor - Packet Based Network - Quality of Service - Wide Area Network SJ-20120814152402-001|2012-08-30 (R1.0) ZTE Proprietary and Confidential...