-
Remove the reservoir cap (2) or (2A) 21 mm wrench and the rubber gaiter.
-
Loosen the bleed valve on the calliper.
-
Pump the brake lever (3) or the brake pedal (3A) until draining all fluid.
-
Tighten the bleed valve and fill the reservoir with fresh fluid.
-
Loosen the bleed valve, operate lever or pedal, tighten the valve keeping
lever or pedal pressed and then release quickly.
-
Repeat the process until the circuit is full and you can see clear fluid coming
out of the plastic hose: now tighten the bleed valve.
-
Top up with fluid up to level (A) or (B) and refit rubber gaiter and reservoir
cover.
After changing the fluid, you will need to bleed air from the circuit.
Part. N. 8000 H1489 (10-2009)
BRAKES
L.9