Ignition And Gear Sensor Cable Connection; Air Box Cable Routing; Clip Installation On Fuse Holders - Husqvarna TC 250 2010 Workshop Manual

• Ignition and gear sensor cable connection

Connect the ignition (26) and gear sensor (27) connectors as shown.
• Routing of rear chassis cables, tail light connection, flasher contactor.
Route the rear end of the wiring (28) as shown in the figure.
Connect the tail light/turning indicators connector (29) (TE).
- Connect the connector (30) to the flasher (TE).
- Connect the connector (31) to the solenoid starter.

• Air box cable routing

Route the wiring harness as shown. Secure it with the suitable clip (32).

• Clip installation on fuse holders

Install the suitable clips (33) on the three fuse holders.
Part. N. 8000 H1489 (10-2009)
ELECTRICAL SYSTEM
M.49
28
31
30
29
H00947