Husqvarna TC 250 2010 Workshop Manual page 93

- Remove the positive power supply cable (29) of the starter motor.
- Disconnect the gear sensor connector (30) and the ignition connectors
(31).
- Shear the clips securing engine wiring to chassis to release the wiring har-
nesses.
- To remove the brake lever (32), use an 8 mm wrench to loosen the master
cylinder linkage (33) and a 6 mm Allen wrench to loosen the central screw
(34). Remove the lever.
Part. N. 8000 H1489 (10-2009)
GENERAL PROCEDURES
E.27
TE-TXC
29
H00675
TE-TXC
30
31
H00676