REAR SUSPENSION
Refit the reservoir cap with its valve. Fit it into the reservoir and fit the circlip
into the groove.
Fill nitrogen (or air) through the valve and pressurise to 10-12 bar. Refit the cap
to the valve and check for oil or air leaks.
Drive the cap onto the body.
Refitting bumper and washer.
If you have replaced the bumper, clamp the rod in a vice with bronze or aluminium
jaws, apply Loctite to the mount and tighten to about 50 Nm. Refit the spring and
set to initial preload using ring nut and lock ring nut.
All liability is disclaimed for any damage resulting from procedures
other than those described in this manual.
L= 248.5-251.5 mm (9.78-9.90 in.)
J.14
Part. N. 8000 H1489 (10-2009)