Husqvarna TC 250 2010 Workshop Manual page 192

ENGINE REASSEMBLY
Operate shifter and transmission shaft to test gearbox for proper operation.
Refit the ratchet assembly (10) together with the plate, making sure ratchets and
springs are in the correct positions.
Tighten the upper screw (11) using a 4 mm Allen wrench (Loctite 243, 10 Nm,
1.0 Kgm, 7.2 ft/lb).
Tighten the lower screw (12) using an 8 mm wrench (Loctite 243, 10 Nm, 1.0
Kgm, 7.2 ft/lb).
Turn the engine over and install the gear shift lever oil seal (13) and its circlip
(14).
H.30 Part. N. 8000 H1489 (10-2009)