4. POWERMASTER-30 G2 INSTALLATION
4.2 Opening the PowerMaster-30 G2 Control Panel and Bracket Mounting
To Mount the Unit:
1. Release the screws
2. Remove the front cover
3. Mark 4 drilling points on the mounting surface
drill 4 holes and insert wall anchors
the back unit with 4 screws
4.3 Connecting to the Telephone Line
(detail "M" in Figure 4.1)
A. LINE
B. SET
Connect the telephone cable to the SET connector and connect the telephone line cable to the LINE connector
(through the desired wiring cable entry).
Notes:
1. The telephone cable should be no longer than 3 meters.
2. For UL installations, the telephone cable must be no less than 26 AWG.
18
, then
and then
fasten
Figure 4.2 – Back Unit Mounting
C. Tel line wall jack
Figure 4.3a – Phone Wiring
A. Mounting surface
B. Back unit
C. Screws
PHONE WIRING
D-304762 PowerMaster-10/30 G2 Installer's Guide