Visonic PowerMaster-10 G2 Quick User Manual page 15

CONNECTING AC POWER USING INTERNAL AC/DC POWER SUPPLY UNIT
PERFORM STEPS 1 and 2 ON A WORKBENCH BEFORE THE MOUNTING
1. Extract either plastic segment (will be used later)
2. Extract plastic segment (will be used later)
3. Knock out the plastic segment (left or right, according
to the power wiring direction)
4. Remove power supply terminals cover (E)
5. Insert the power cable through the desired wiring
channel, route it to the power supply unit and connect
its 2 wires to the power supply terminal block with a
screwdriver. Fasten the screws tightly.
Verify that the wires are properly fastened!
6. Insert plastic cap to the power cable entry (extracted
in step 1)
D-304762 PowerMaster-10/30 G2 Installer's Guide
7. Fasten power cable by clamp (extracted in step 2)
8. Close power supply terminals cover
9. Connect the DC output cable plug into the DC input
socket located on the front panel.
A. Internal AC/DC power supply unit
B. Power cable clamp options
C. For thin cable
D. For thick cable (reversed clamp)
E. Terminals cover
F. DC input socket on front panel
G. DC output cable
Figure 3.7b – Power Cable Wiring
3. POWERMASTER-10 G2 INSTALLATION
15