Setting Installer Codes - Visonic PowerMaster-10 G2 Quick User Manual

– Exiting the Installer Mode
[1] To exit "INSTALLER MODE", move up the menu by pressing the
reads "<OK> TO EXIT" or preferably; press the
screen "<OK> TO EXIT".
When the display reads "<OK> TO EXIT", press
[2]
The system exits the "INSTALLER MODE" menu and returns to the normal disarm state while showing the
[3]
READY display.

5.3 Setting Installer Codes

The PowerMaster system provides two installer permission levels with separate installer codes, as follows:
Master Installer: The "Master Installer" is authorized to access all Installer Menu and sub-menu options. The
•
default code is: 9999 (*).
• Installer: The "Installer" is authorized to access most but not all Installer Menu and sub-menu options. The default
code is 8888 (*).
• Guard Code: Enables an authorized guard to only Arm Away / Disarm the control panel. The default code is 0000 (*).
The following actions can be performed only by using the Master Installer code:
Changing the Master Installer code.
•
• Defining specific communication parameters – see "3:C.S REPORTING" in sections 5.6.1 and 5.6.4.
Resetting the PowerMaster parameters to the default parameters – see "09:FACTORY DEFLT" in section 5.11.
•
Note: Not every system includes a Master Installer code feature. In such systems, the Installer can access all Installer
Menu and sub-menu options the same as a Master Installer.
(*) You are expected to use the default codes only once for gaining initial access, and replace it with a secret
code known only to yourself.
To change your Master Installer or Installer Codes proceed as follows:
Step 1
Select "01:INSTALL
CODES" Option
INSTALLER MODE
ENTER CODE:
01:INSTALLER CODES
– Setting Installer Codes
Enter the Installer Menu and select the "01:INSTALL CODES" option (see section 5.2).
[1]
Select the "NEW MASTER CODE", "NEW INST. CODE" or "NEW GUARD CODE". Some panels may have
[2]
only the Installer Code and New Guard Code option.
[3] Enter the new 4-digit Code at the position of the blinking cursor and then press
Notes:
1. Code "0000" is not valid for Master Installer. It is recommended NOT to use it also for the Installer.
2. Warning! Always use different codes for the Master Installer, for the Installer and for the Users.
A. If the Master Installer Code is identical to the Installer code, the panel will not be able to recognize the
Master Installer. In such a case, you must change the Installer code to a different code. This will re-
validate the Master Installer code.
B. If a User code is identical to the Master Installer or Installer codes, the system will no longer be able to
recognize the Installer code. In such a case, you must enter the "User Settings" menu and change the
User code to a different code. This will re-validate the Installer code.
D-304762 PowerMaster-10/30 G2 Installer's Guide
Step 2
[1] Select Master Installer,
Installer code or Guard
code
NEW MASTER CODE
or
NEW INST. CODE
or
NEW GUARD CODE
button repeatedly until the display
button once which brings you immediately to the exit
.
Step 3
[2]
Enter NEW Master Installer,
Installer code or Guard code
MASTER CODE: 999
or
INST. CODE: 888
or
GUARD CODE: 000
5. PROGRAMMING
Step 4
[3]
to step 2
to step 2
to step 2
.
29