Maintenance; Handling System Troubles - Visonic PowerMaster-10 G2 Quick User Manual

7. MAINTENANCE

Option
7. MAINTENANCE

7.1 Handling System Troubles

Fault What it means
1-WAY The control panel cannot configure or control
the device.
Battery consumption increases.
AC FAILURE There is no power to gas sensor
1
Depending on shock detector model, one of the following may appear instead: "Zxx:Shk+AX" / " Zxx:Shk+CntG3" /" Zxx:Shk+CntG2".
70
Instructions
"MOTION SENSORS".
2. Press ; the following screens will appear: "Z01:Motion Sens"
3. Press continuously to navigate to a different zone number.
4. Press ; If the selected device is Tower-32AM PG2, the following screens will appear:
"<OK MW ADJUST>"
To test the microwave range, go to step 5. To test a different microwave range, go to step 7.
5. Press ; the following screen will appear: "ACTIVATE MW NOW".
6. Activate the device; the screen will return to "TEST ONE DEVICE".
You can now repeat the procedure for another dual detector.
7. Press to select the sensitivity setting.
8. Press continuously to select between "Minimum" (default), "Medium" or "Maximum"
9a. Press ; the panel will receive an acknowledge from the device that is indicated by a
black box next to the selected setting. Thereafter, the screen momentarily changes to
"ACTIVATE MW NOW" and then returns to the selected setting.
9b. If you press
Important: The procedure mentioned above is for testing purposes only and does not change
the detector settings. The settings must be saved through the MODIFY DEVICES menu.
To test the shock detector:
1. Press to enter the "TEST ONE DEVICE" sub menu and use
"SHOCK SENSORS".
2. Press ; the following screens will appear: "Zxx:Shk+AX+CntG3"
3. Press continuously to navigate to a different zone number.
4. Press ; the following screens will appear: "Zxx ACTIVATE NOW"
ACTIV." "CNTACT NOT ACTIV"
Note: The above screens are the full range of screens that can appear and indicate the
inputs that have not yet been activated. However, since there are various models of the
shock detector, not all of these screens will appear on some models.
5. At this stage, activate each input of the shock detector in turn.
"<NEXT> TEST ONE".
, the adjustment procedure ends.
"AUXIL. NOT ACTIV".
Solution
1. Make sure the device is physically present.
2. Check the display for device faults, for
3. Use RF diagnostics to check the current
4. Open the device cover and replace the
5. Install the device in a different location.
6. Replace the device.
Make sure that the AC power supply is
connected properly
D-304762 PowerMaster-10/30 G2 Installer's Guide
<location>.
to navigate to
1
example, low battery.
signal strength and during the last 24
hours.
battery or press the tamper switch.
<location>.
"SHOCK NOT