Powermaster-10/30 G2 Quick User Guide - Visonic PowerMaster-10 G2 Quick User Manual

PowerMaster-10/30 G2 Quick User Guide

Arming and Disarming the System
Step
1 Press the Partition Selection button and then
select a PARTITION (if Partition is enabled) –
used to divide the alarm system into three
independently controllable areas
2 Arm AWAY - used to arm the system when the
protected site is vacated entirely.
Arm HOME – used to arm the system when
people are present within the protected site.
Disarm (OFF) – used to restore the control panel
to the normal standby state
Quick arm AWAY (If Quick Arm is enabled) –
used to arm in the AWAY state without a user
code
Quick arm HOME (If Quick Arm is enabled) –
used to arm in the HOME state without a user
code
Forced arming AWAY (system not ready) – used
to arm the alarm system in the AWAY state when
any of the system zones is disturbed.
Note: Forced Arming is not to be enabled in UL
Listed Product.
Forced arming HOME (system not ready) – used
to arm the alarm system in the HOME state when
any of the system zones is disturbed.
Note: Forced Arming is not to be enabled in UL
Listed Product.
3 INSTANT – used to arm in the Instant mode,
without an entry delay.
LATCHKEY – used for keyfob transmitters 5
through 8 (PowerMaster-10 G2) / 23-32
(PowerMaster-30 G2)
Note: The factory default master user code is 1111. The code is not required if quick arming has been permitted
by the installer. Change the factory default code to a secret code without delay (see section Chapter 6 of the
PowerMaster-10/30 G2 User's Guide, section B.4-Programming User Codes).
Initiating Alarms
Alarms
Emergency alarm
Fire alarm
Panic alarm
Preparing to Arm
Before arming, make sure that READY is displayed.
HH:MM READY
If at least one zone is open (disturbed) the display will read:
HH:MM NOT READY This indicates that the system is not ready for arming and in most cases that one or more
Operation
Actions
(≈ 2 sec.)
(≈ 2 sec.)
(≈ 2 sec.)
+
This indicates that all zones are secured and you may arm the system as desired.
zones are not secured. However, it can also mean that an unresolved condition exists
such as certain trouble conditions, jamming etc., depending on system configuration.
PowerMaster-10/30 G2 Quick User Guide
User Actions
followed by any
combination of
,
, or
+ [ ] or enter code
+ [ ] or enter code
+ [ ] or enter code
+ [ ] or enter code
to silence the "protest"
buzzer
+ [ ] or enter code
to silence the "protest"
buzzer
(After arming HOME/AWAY)
Notes
To stop the alarm, press
your valid user code.
Notes
A "protest" beep will be
heard when selecting a
partition to which no
sensors / peripherals
were enrolled.
ARM indicator
lights steadily during
the armed state.
ARM indicator
extinguishes during the
disarmed state.
Disarming the system
also stops the siren
alarm, irrespective of
whether the alarm was
initiated during the
armed or the disarmed
state.
and then key in