Kyocera KM-C2525E Service Manual page 53

Maintenance
item No.
Checking the operation of the solenoids
U033
Description
Applies current to each solenoid in order to check its ON status.
Purpose
To check the operation of each solenoid.
Method
1. Press the start key.
2. Select the solenoid to be operated. The selected solenoid turns on for 1.5 s.
Display
Branch Inner Tray
Eject Branch Solenoid
MPT Pick up Solenoid
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
Adjusting the print start timing
U034
Description
Adjusts the leading edge registration or center line.
Purpose
Make the adjustment if there is a regular error between the leading edges of the copy image and original.
Make the adjustment if there is a regular error between the center lines of the copy image and original.
Method
1. Press the start key.
2. Select the item to be adjusted.
Display
Timing
Center Adjust
Timing B/W*
*: Displayed by 40/35 ppm model only
Adjustment: Leading edge registration adjustment
1. Select [Timing] or [Timing B/W].
2. Select the item.
When [Timing] is selected
Display
MPT (Large)
MPT (Small)
MPT Half (Large)
MPT Half (Small)
Cassette (Large)
Cassette (Small)
Duplex (Large)
Duplex (Small)
Large size: 218 mm or more in width of paper.
Description
Solenoid
Feedshift solenoid 1 (FSSOL1)
Feedshift solenoid 2 (FSSOL2)
MP solenoid (MPSOL)
Description
Leading edge registration adjustment
Center line adjustment
Leading edge registration adjustment in monochrome mode
Description
Paper feed from MP tray
Paper feed from MP tray
Paper feed from MP tray
Paper feed from MP tray
Paper feed from cassette
Paper feed from cassette
Duplex mode (second)
Duplex mode (second)
Setting Default Change in
range setting value per step
-3.0 to 3.0 0 0.1 mm
-3.0 to 3.0 0 0.1 mm
-3.0 to 3.0 0 0.1 mm
-3.0 to 3.0 0 0.1 mm
-3.0 to 3.0 0 0.1 mm
-3.0 to 3.0 0 0.1 mm
-3.0 to 3.0 0 0.1 mm
-3.0 to 3.0 0 0.1 mm
2JL/2JJ/2JG/2JD-1
1-3-13