Kyocera KM-C2525E Service Manual page 25

Removing the eject spacer.
1. Remove the eject spacer and silicagel from the eject
section.
Removing the tapes and spacers.
1. Remove two tapes.
2. Remove the spacer from cassette 1.
3. Pull the lever and operation section is lowered.
4. Remove two spacers.
Remove waste textile on the operation panel, if any.
Installing the optional paper feeder.
1. Install the optional paper feeder as necessary.
2. Verify levelness at the four corners of the contact glass using a level gauge, and adjust the
level bolts at the bottom of the machine to optimize levelness.
Silicagel
Eject spacer
Figure 1-2-4
Spacer
Lever
Tape
Spacer
Figure 1-2-5
2JL/2JJ/2JG/2JD
Operation section
Spacer
Tape
1-2-5