Kyocera KM-C2525E Service Manual page 295

(2) Switches and sensors
21
35
11
34
10
23
22
6,7,8
29
30
12
42
31
1. Main power switch (MSW) ........................... Turns the AC power on and off.
2. Toner sensor M (TS-M) ................................ Detects the toner density in the developing unit (Magenta).
3. Toner sensor C (TS-C)................................. Detects the toner density in the developing unit (Cyan).
4. Toner sensor Y (TS-Y) ................................. Detects the toner density in the developing unit (Yellow).
5. Toner sensor BK (TS-BK) ............................ Detects the toner density in the developing unit (Black).
6. ID sensor 1 (IDS1) ....................................... Measures image density for color calibration.
7. ID sensor 2 (IDS2) ....................................... Measures image density for color registration.
8. ID sensor 3 (IDS3) ....................................... Measures image density for color registration.
9. Waste toner sensor (WTS)........................... Detects when the waste toner box is full.
10. Front cover switch (FCSW).......................... Breaks the safety circuit when the front cover is opened.
11. Left cover 1 switch (LC1SW) ....................... Breaks the safety circuit when the left cover 1 is opened.
12. Left cover 2 switch (LC2SW) ....................... Breaks the safety circuit when the left cover 2 is opened.
13. MP tray switch (MPTSW) ............................. Detects the MP tray extension is extend.
14. MP paper length size switch (MPPLSW) ..... Detects the length of paper on the MP tray.
15. MP paper width size switch (MPPWSW) ..... Detects the width of paper on the MP tray.
16. MP paper set switch (MPPSSW) ................. Detects the presence of paper on the MP tray.
17. MP paper feed switch (MPPFSW) ............... Detects a paper misfeed in the MP tray paper feed section.
18. Transfer detection sensor (TRDS) ............... Detects positioning of transfer belt rotation.
19. Original size detection sensor (OSDS) ........ Detects the size of the original.
20. Original detection switch (ODSW) ............... Detects the opening/closing of the original platen (or DP).
21. Home position switch (HPSW)..................... Detects the optical system in the home position.
22. Duplex jam detection switch (DUJDSW)...... Detects a paper misfeed in the duplex section.
28
18
41
33
5
36
32
38
26
37
39
27
Figure 2-2-2 Switches and sensors
19
4 3 2
40
43
17
24
25
2JL/2JJ/2JG/2JD-1
20
1
9
16
15
Machine front
Machine inside
Machine rear
14 13
2-2-3