SL mille
6.12.3 CHANGING THE REAR LIGHT BULB
Carefully read 0.4.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
NOTE
The rear light houses two parkinglightlstoplight
bulbs. The following operations refer to a single bulb, but
are valid for both.
Before changing a bulb, check the efficiency of the stop-
light switches, see 6.16 (CHECKING THE SWITCHES).
• Remove the passenger seat, see 7.1.2 (UNLOCKING/
LOCKING THE PASSENGER SEAT).
Do not pull tile
E!lectri~V\lirE!!)t()~)(trCl~t
the bulb sock-
et.
NOTE
The bulb socket (1) is provided with a special
wing to facilitate the rotation of the socket itself.
• Working on the glove/tool kit compartment side, grasp
the bulb socket(1) and rotate it anticlockwise.
• Slide out the bulb holder (1).
• Press the bulb (2) slightly and rotate it anticlockwise.
• Extract the bulb (2) from its seat.
Insert the bulb in the bulb socket, making the two
bulb pins coincide with the relevant guides on the
socket.
• Correctly install a new bulb of the same type.
6.12.4 CHANGING THE NUMBER PLATE BULB
Carefully read 0.4.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
Do not pull
et.
• Working on the lower side of the number plate holder,
grasp the bulb socket (3), pull it and extract it from its
seat.
• Withdraw the bulb (4) and replace it with a new one of
the same type.
ELECTRIC SYSTEM
Release 00/2001-05 - - - - - - - - - -
11-
43-00