Reading Current Values - DeDietrich C230 ECO-A 120 Installation, Operating And Service Manual

C230 ECO-A
Fig. 21 Reading current values

9.1.3 Reading current values

The following current values can be read in the 'information
menu'
 5t = Status
 5v = Sub status
 t1 = flow temperature [°F];
 t2 = return temperature [°F];
 t4 = outside temperature [°F] (only if outside sensor is
connected);
 t6 = boiler block temperature [°F];
 5p = internal set point [°F];
 fl = ionization current [µA];
 nf = fan rotation speed [rpm];
 pr = water pressure [inches w.c.];
 p; = relative output supplied [%];
The current values can be read as follows:

Press the key, the
key;
with the
 Press the [+] key again so that 5t appears alternating
with 3, the actual status;
 Press the [+] key again so that 5v appears alternating
with 0, the actual sub status;
 Press the [+] key again so that t1 appears, alternating
with, for example, 140°F (60°C), the actual flow
temperature;
 Press the [+] key repeatedly so that the remaining
temperatures also appear;
 Press the [+] key again so that 5p appears, alternating
with, for example, 190°F (88°C), an internal set point;
 Press the [+] key again so that fl appears alternating
with, for example, 70v, the actual ionization current;
 Press the [+] key again so that nf appears alternating
with, for example, 3000 (rpm), the actual fan rotation
speed;
 Press the [+] key again until pr appears alternating and,
for example, 40.0 psi (2.8 bar), the actual water
pressure

(if no water pressure sensor is connected, --.- psi
appears);
 Press the [+] key again until p; appears and, for
example, 78%, the actual modulation percentage;
 Press the [+] key again, the read-out cycle starts again with
5t, etc;

Press the key twice to return to the display with the
current operating status.
symbol will then flash, confirm
9 Commissioning
51