Maintaining The Installation; Viewing The Service Notification; Reading Out Measured Values; Viewing Production And Software Information - DeDietrich C 340 Series Installation And User Manual

9 Installer instructions
9.4

Maintaining the installation

Fig.94 Installer level
........ ....... ........ ......... ...
00:12
..... ... ....... .... .. ..... ....... .... ..... .......
i
........ .......
0
0 0 1
1 1 2
2 2 3
3 3 4
4 4 5
Fig.95 Parameters, counters, signals
A
11:20 ... ..... .... ...... : .... ...... ....
............ ................
..... ... ....... .... .. ..... ....
B
....... .... .. ..... ....
....... ...........
..... ... ....... ....
..... ... ....... ....
........ .......
82 C 340 / C 640
0
1
2
3
4
5
6
AD-3001378-02
..............
.........
.......
...
......
.....
.....
AD-3000936-02
9.4.1

Viewing the service notification

When a service notification appears on the display, you can view the
details of the notification.
1. Select the tile [ ].
2. Press the button to confirm the selection.
The View Service Notification menu opens.
3. Use the rotary knob to select the parameter or value you want to view.
9.4.2

Reading out measured values

The control unit continually registers various values from the boiler and the
connected sensors. These values can be read on the control panel of the
boiler.
1. Select the tile [ ].
2. Press the button to confirm the selection.
3. Use the rotary knob to select code: 0012.
4. Press the button to confirm the selection.
When the installer level is enabled, the status of the tile [
changes from Off into On.
5. Press the button.
6. Use the rotary knob to select Installation Setup.
7. Press the button to confirm the selection.
8. Use the rotary knob to select the zone or device you want to read out.
9. Press the button to confirm the selection.
10. Use the rotary knob to select Parameters, counters, signals.
11. Press the button to confirm the selection.
12. Use the rotary knob to select Counters or Signals to read out a
counter or signal.
13. Press the button to confirm the selection.
14. If available, select Adv. Counters or Adv. Signals to read out counters
or signals at the advanced installer level.
A Parameters
Counters
Signals
Adv. Parameters
Adv. Counters
Adv. Signals
B List of settings or values
9.4.3

Viewing production and software information

You can read details about the production dates, hardware and software
versions of the appliance and all connected devices.
1. Press the button.
2. Use the rotary knob to select Version Information.
3. Press the button to confirm the selection.
]
7762666 - v.02 - 29092020