Table 8-3 Removal workflow and procedures
Item
Replacement work procedure
1
Removing a PCI Express card cassette
2
Removing a PCI Express card
3
Installing a PCI Express card filler
4
Installing a PCI Express card cassette
8.4
Removing a PCI Express Card
This section describes the procedure for removing a PCIe card. Enable removal of the
PCIe card before attempting to remove it. For details, follow the procedure in
"Chapter 7 Maintenance
Caution - Before you handle any components, wear a wrist strap to ground any static
electricity. If you perform this procedure without a wrist strap, individual
components or the overall system may be damaged. For details, see
on Static
8.4.1
Removing a PCI Express card cassette
There are two types of PCIe card cassette. The shapes of the latch (A in the figure)
and lever (B in the figure) vary depending on the type of the PCIe card cassette, but
the same removal procedure applies. For the types of PCIe card cassettes, see
8-3."
Unless otherwise specified, the figures explained in this section use Type-1.
202
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual ・ June 2023
Reference
"8.4.1 Removing a PCI Express card
"8.4.2 Removing a PCI Express
"8.4.3 Installing a PCI Express card
"8.5.3 Installing a PCI Express card
Flow."
Electricity."
cassette"
card"
filler"
cassette"
"1.5 Precautions
"Figure