8.5.3
Installing multiple communication units in layers
This section describes how to install another communication unit on the communication unit that has been
installed on the GOT.
When no communication unit is installed on the GOT, apply the steps in this section after installing a
communication unit. (
1
Remove the connector cover and seal from the installed communication unit.
2
Install the unit on outside of the unit that has been installed.
3
After installing the unit, fasten it by tightening the mounting screws (2 places) with tightening torque of
0.36 to 0.48N·m.
8.5.2 Installing procedure)
8.5.3 Installing multiple communication units in layers
Connector cover
Seal
8.5 Communication Unit
1
2
3
4
5
6
7
8
8
- 18