5
Remove the case after passing the battery holder through the mounting hole.
When removing, take care of not cutting the cable of the battery holder.
(Expanded figure of part A in
6
Disconnect the cable connector of the upper (H01) backlight and the cable connector of the lower (H02)
backlight from the GOT side connectors.
7
Pull the upper backlight by pressing the projecting part of the rubber holder that fixes the backlight with
a minus driver to unfasten the backlight.
In the same way, pull the lower backlight by pressing the projection part of the rubber holder that fixes
the backlight with a minus driver to unfasten it.
(Expanded figure of part A in
)
A
)
6
A jut of the rubber holder
19.6.2 Replacement procedure of backlight
19.6 Backlight Replacement
17
18
19
20
19
- 7