Mitsubishi GOT1000 GT15 User Manual page 124

(4) Channel number specification menu BOX
Set channel No. to use with standard interface or extend interface.
Refer to this section (5) for driver that can be assigned to each channel.
0: Set when the communication interface is not used.
1 to 4 :Set when connecting to a controller (Bar code reader is excluded.)
8: Set when connecting with bar code reader.
9: Set when connecting with PC (GT Designer2). (For USB and RS-232 interface, the
simultaneous setting is possible. However, when either interface is during communication,
communication is not possible for another interface.)
*: Set when using the gateway function (Connection to the controller is made with other than
Ethernet.) and Ethernet download function.
• 5 to 7 can not be set.
• Fixed to 9 for the USB interface.
(5) Driver display BOX
The name of communication driver assigned to the channels or the driver set with the
Communication Setting of GT Designer2 is displayed.
The displayed names are shown below.
Driver name
Q BUS (Q)
A/QnA BUS
A/QnA/Q CPU, QJ71C24
MELSEC-FX
AJ71QC24
AJ71UC24/C24
MELSECNET/10
CC-Link(ID)
CC-Link(G4)
E71 Connection
10
10.1 Communication Setting
- 3
10.1.3 Communication setting contents
Compatible connection type
Bus connection
Direct CPU connection, computer link
connection, CNC connection
Direct CPU connection
Computer link connection
Computer link connection
MELSECNET/10 connection (PLC to PLC
network), CNC connection
CC-Link connection (Intelligent device station)
CC-Link connection (Via G4)
Ethernet connection, CNC connection
Displayed interface
Extend interface display
BOX
( This section (3))
Standard interface
display BOX: RS232
( This section (2))
Extend interface display
BOX
( This section (3))
Extend interface display
BOX
( This section (3))
(Continue to next page)
Corresponding
channel No.
1 to 4