Mitsubishi GOT1000 GT15 User Manual page 102

4 When installing another communication unit on the outer layer, implement the above operations of
4 When not installing a communication unit on the outer layer, cover the top of mounting screws with
accessory labels in order to avoid receiving static electricity.
4 Keep the connector cover fixed.
4 Keep the seal stuck as it is.
5
8
8.5 Communication Unit
- 19
8.5.3 Installing multiple communication units in layers
Accessory
labels
Connector
cover
(1) Installation position for a communication unit that occupies two Extend I/Fs
For communication units that occupy two Extend I/Fs as shown below, install
them directly on the GOT main unit.
They cannot be installed on outside of other communication units.
• Bus connection unit (GT15-QBUS2, GT15-ABUS2, GT15-75QBUS2L,
GT15-75ABUS2L only) (
• MELSECNET/10 communication unit (
communication unit, CC-Link communication unit)
• CC-Link communication unit (
communication unit, CC-Link communication unit)
(2) Removing the GT15-QBUS2, GT15-ABUS2
Before removing the unit, unscrew the extend interface relay board fixing screws.
( 8.5.2 (2)GT15-QBUS2, GT15-ABUS2)
Seal
8.5.3 Bus connection unit )
8.5.3
8.5.3 MELSECNET/10
to .
MELSECNET/10