Mitsubishi GOT1000 GT15 User Manual page 98

5 When installing a communication unit on the outer layer, refer to the following.
8.5.3 Installing multiple communication units in layers
When not installing a communication unit on the outer layer, cover the top of mounting screws (4
places) with accessory labels in order to avoid receiving static electricity.
Keep the connector cover fixed.
Keep the seal stuck as it is.
(2) Terminal block socket installation (For GT15-RS4-TE only)
1 Insert the terminal block socket in the serial communication unit.
2 Fasten the terminal block by tightening the terminal block fixing screws (2 places) with the
tightening torque of 0.20 to 0.25 N·m.
8
8.5 Communication Unit
- 15
8.5.2 Installing procedure
Accessory
labels
Connector
cover
Remove the serial communication unit, ethernet communication unit
If you remove the serial communication unit or ethernet communication unit, detach
it from specified direction (shown PULL) so as not to break a connector.
(Extended figure of part A)
A terminal block fixing screw
When attaching or removing a communication cable
When attaching or removing a communication cable to/from the terminal block
socket, detach the terminal block socket from the connector.
(When communication units are installed in multiple layers, the units do not have to
be removed from the GOT main unit.)
Seal
A