Installing When Starting The Got - Mitsubishi GOT1000 GT15 User Manual

18.3.1 Installing when starting the GOT

The displayed message is different depending on the installation condition of standard monitor OS. When
the screen requesting operation is displayed, operate the GOT according to the instructions on the screen.
1 Operation procedure
1 Power OFF GOT and CF card access switch. Insert the CF card in which BootOS, standard monitor OS
or project data is stored in the CF card interface of GOT.
2 Switch ON the CF card access switch of GOT.
3 Power on the GOT.
• For GT1595-X
Power on the GOT while pressing the installation switch (S.MODE switch) on the back of the GOT. (1-
point press installation function)
• For GT1585-S, GT1575-S, GT1575-V, GT1575-VN, GT1572-VN, GT1565-V,GT1562-VN
Power on the GOT while touching the upper and left of the GOT screen. (2-point presses installation
function)
Installation switch
( S. MODE )
4 BootOS, standard monitor OS is installed in the built-in flash memory.
The CF card access LED is lit during install execution.
Do not pull out the CF card or power OFF the GOT while the CF card access LED is lit.
5 GOT restarts automatically after installation is completed.
(When standard monitor OS is already installed, GOT restarts by touching
6 After confirming normal restart, switch OFF the CF card access switch of GOT. When it is confirmed that
CF card access LED is not lit, remove the CF card from the CF card interface of GOT.
18
18.3 BootOS and Standard Monitor OS Installation Using Memory Card
- 5
18.3.1 Installing when starting the GOT
For GT1595-X
Now installing BootOS.
Reboot.
Simultaneous
2-point touch
For GT1585-S, GT1575-S/V/VN, GT1572-VN,
GT1565-V, GT1562-VN
button.)
OK