Mitsubishi GOT1000 GT15 User Manual page 315

6 Disconnect the cable connector of the upper (H01) backlight and the cable connector of the lower (H02)
backlight from the GOT side connectors.
7 Remove the cables of the upper connector (H01) from the 2 slits (black).
Similarly, remove the cables of the upper connector (H02) from the 2 slits (black).
8 Press the upper backlight fixing latch (black) with your finger, and pull out the backlight to the left.
Similarly, press the lower backlight fixing latch (black) with your finger, and pull out the backlight to the
left.
Latch
9 Mount a new backlight in the reverse procedure of removal.
10 When connecting the cable connectors of the backlight and the GOT unit, connect by crossing the cable
connectors each other as the below.
Also assemble the case in the reverse procedure of disassembly. (Tighten the GOT rear fixing screws
within the torque range of 0.36 to 0.48N·m).
When mounting the case, take care of not biting the cables between the case and the GOT.
(Expanded figure of part A in
B
A
B
(Expanded figure of part B in
19.6.2 Replacement procedure of backlight
)
6
)
6
19.6 Backlight Replacement
17
18
19
20
19
- 13