Connection Of Peripheral Units Of Got - Mitsubishi F940GOT-SWD-E Operation Manual

Graphic Operation Terminal F940GOT
1.5.2

Connection of peripheral units of GOT

The figure below shows the system configuration required to use the GOT with peripheral
devices.
Graphic operation terminal
F940GOT-SWD/LWD-E
Data transfer
cable
FX-232CAB-1
Computer link
(disabled during
RS-232C communication)
Printer
< Dedicated printers >
GT-10A
K6PR(-K), A7(N)PR
< General-purpose printers >
ESC/P
Printer equipped with
RS-232C interface
(Prints out sampling data,
alarm history and alarm
messages.)
Data transfer cable FX-232CAB-1
(when the RS-232C connector in the PC is 9-pin type),
Data transfer cable FX-232CAB-2
(when the RS-232C connector in the PC is half-pitch, 14-pin type) or
Data transfer cable F2-232CAB-1
(when the RS-232C connector in the PC is 25-pin type)
Attach a ROM to the
F9GT-40UMB, then
connect it to a connector
provided on the rear face
of the GOT.
EPROM memory
FX-EPROM-4M
(User screens can
be stored using a
general-purpose
ROM writer.)
ROM writer
General-purpose ROM writer
General-purpose personal computer
(screen creation software)
FX-PCS-DU/WIN-E (V2.00) or
SW¨D5C-GOTRE-PACK ("¨" is a
numeric not less than 1.)
Printer
PC-PR201H or its equivalent
ESC/P
* A7(N)PR is available
for the A7PHP/HPG.
(Prints out screen data,
sampling data, etc.)
Peripheral units of GOT
Introduction 1
1-10