Table of Contents
Advertisement
You may want to install a LED to monitor the SCSI bus activity. This is possible by
installing a cable to the J10 SCSI LED Connector. See Appendix E for recommended
mating parts.
TABLE 6-4: SCSI LED Connector (J10) - Pinout
Pin Number
1
2
* Active low signal
Finally, you must also install a cable from your power supply to your SCSI device.
6.03.2 INSTALLING OTHER SCSI DEVICES
To install any of the following: CD-ROM, Magneto-Optical/Removable Disk Drive, Tape
Drive, Write Once Read Many (WORM) and scanners, contact TEKNOR's Technical
Support department for more information.
Installing IDE, Floppy & SCSI Devices
Signal
VCC (+5V)
LED-CTL*
6-12
Advertisement
Table of Contents
