Table of Contents
Advertisement
11.07 BATCH MODE
While files can be manually selected using the Interactive Mode, automatic transfers of a
predefined area (a sub-directory or preferably a diskette) can be achieved through Batch
Mode.
In Batch Mode, a user or field technician with no previous knowledge of the system can
easily effect a transfer to the Flash disk. This can be done either by calling a batch file
(*.bat) or by simply issuing the proper command line parameters directly from DOS.
When the transfer is complete, reset the system. This allows the BIOS and DOS to
recognize the new Flash disk.
Keep in mind that Batch Mode can be called directly from a floppy or hard disk, from a
remote computer, or from a portable computer. In each case, the selected files can be
downloaded to the Flash devices.
Batch Mode returns error codes (error level) that can be read by a DOS batch file or by a
high level language program.
11.07.1 BATCH MODE COMMAND LINE PARAMETERS
The command line format is as follows:
VFLASH [drive:] [\directory] [destination] [options]
where:
[drive:]
is the source drive from which a complete copy will be made if no
directory is specified (see section 11.04, for more information).
[\directory]
is the path used to show from which directory the source files will be
taken and transferred to the Flash or EPROM files. If you do not specify
a directory (for example, VFLASH B:\), only the files in the root
directory will be transferred to the Flash disk. Also, if the Flash disk is
to be bootable, the /B option must be used.
Each option or switch starts with a '/' character followed by one or more letters. These
letters are in uppercase and are used by VFLASH to identify a specific option.
VFLASH Software
11-14
Advertisement
Table of Contents
