Output Selection/Second Screen - Teknor Industrial Computers VIPer807 Technical Reference Manual

11.03 OUTPUT SELECTION/SECOND SCREEN

Once onboard or external Flash is selected, a second screen appears as follows.
Output selected: On board FLASH devices.
Choose the size of the disk using the arrow keys:
Legend: selected block = , unselected block =
DISK SIZE: 640 Kbytes (minimum: 128Kbytes)
↑ ↓ → ← Enter to select option Special disk
On the first line, the output selected will be displayed ("On board FLASH devices" or
"External FLASH devices via serial link".
The rest of the screen allows you to divide or partition the Flash disk according to your
needs. The default disk always starts at the beginning of the Flash space and the size is all
Flash selected. Therefore, a full bar will be displayed below the legend.
Directly below the bar is an END pointer. It shows where the Flash partition ends. The
next line shows physical parameters such as the DISK SIZE of selected blocks. It also
shows the minimal partition size you have available. The minimal disk size can be altered
by the /G:x option (for details on this option, please refer to Section 11.07 - BATCH
MODE).
To set the size of the disk, move the END pointer with the horizontal keys.
OUTPUT SELECTION FOR THE TRANSFER
↑ End
VFLASH Software 11-5