Table of Contents
Advertisement
10.01.1 VIP-UP SCREEN
TEKNOR MICROSYSTEMS INC --- VIPer SETUP
TEKNOR BIOS Extension Address
Disks C: to E: Configuration (BIOS Int 13h)
Disk C: Configuration
Disk D: Configuration
Disk E: Configuration
Enter VIP-UP Message
VT100 & Serial Download Speed
VT100 & Serial Download Serial Port
On Board SCSI Device
On Board SCSI BIOS
Use Flash To Store CMOS RAM SETUP
Flat Panel VGA Controller Display Mode
↑↓ to select options
PgDn(+), PgUp(-) to change an option
The screen's options are described below:
1. Selection of TEKNOR BIOS Extention address: The address of the Teknor BIOS Extension
is set here. The Teknor BIOS Extension options are CC000h-CFFFFh and DC000h-
DFFFFh.
2. Disks C: to E: Configuration (BIOS Int 13h): The Disk Configuration locations (C, D, E)
can be user-defined by setting the first parameter "Disks C: to E: Configuration (BIOS Int
13h)" to "Enabled". You can then associate the disks present (e.g., Hard Disk 0, Hard Disk
1, Flash disk) to the drive letter desired. The disk you want to boot from must be configured
as "Disk C:". Never assign a letter to a disk that is not present. Never skip a drive letter (e.g.,
the following is not valid: C: assigned to a disk, D: "Not Installed", E: to another disk).
Although the BIOS does not prevent it, you should not configure the same disk (Hard Disk
0, Hard Disk 1 or Flash Disk) at two or more locations (C, D or E), for example, Hard Disk
0 at D and E.
3. Enter VIP-UP message: This option allows the user to enable or disable the message "Press
CTRL-V to enter TEKNOR VIP-UP" at the top of the screen upon boot-up.
4. VT100 & Serial Download: The VT100 & Serial Download Speed option is for selecting
the desired speed for the VT100 and Download modes. The VT100 & Serial Download
Serial Port option allows the use of either COM2 or COM1 for the VT100/Serial Download
Mode hookup.
VIPer Software Setups
CC000H-CFFFFH
Disabled
Not Installed
Not Installed
Not Installed
Displayed 3 seconds
19200 BPS
COM1: 3F8H
Enabled
Enabled
No
CRT Only
ESC - Quit without saving
F10 - (U)pdate Flash BIOS
10-2
Advertisement
Table of Contents
