Table of Contents
Advertisement
/R
Instructs VFLASH to reset the VIPer807 upon completion of download
operation. This is valid only in VT100 Mode. In Download Mode, the remote
system is always reset.
/S
Used to create a special disk or partition. This option precedes the starting
device number option (/#order) or the disk size option (/sizeK), or both.
/#order
Specifies the Flash block to be used as the starting point for a disk partition
(default setting is #1).
/sizeK
Specifies a special disk size, in KB, for the Flash disk. The default setting is
the largest disk size following the designated starting disk, as selected in the
/#order option).
/V:volume label
This switch specifies a volume label for the disk to be created. This option will
report an invalid command line error if it is used while transferring a complete
copy of a floppy disk. Since it is acceptable to have spaces in a volume label, do
not place this switch before [drive:], [\directory] or [destination], since
VFLASH would not be able to determine when the label ends and when these
options begins.
To get a summary of the Batch Mode options from VFLASH, simply run VFLASH with
the command line '/?' or '/HELP' (type 'VFLASH/?' or 'VFLASH/HELP'). Either command
will display a Batch options summary and some examples of valid VFLASH command
lines. The same help information will also be displayed each time VFLASH detects an
error in the command line.
VFLASH Software
11-16
Advertisement
Table of Contents
