Table of Contents
Advertisement
11.06.2 TRANSFER STATUS OF EXTERNAL FLASH PROGRAMMING SCREEN
When a serial link is used, the following screen will be displayed:
TRANSFER STATUS OF EXTERNAL FLASH PROGRAMMING
Erasing of all Flash devices installed, please wait. . .
Erase completed
Creating a bootable Flash disk
Transferring the BOOT sector, FAT and root DIR. . .
Completed
Copying selected files. . .
Transfer completed: XX. X%
Transferring: FILENAME
Elapsed time: Xmin XXsec
Transfer complete
The above screen is used to display the transfer operation status. It shows each step in
progress:
1. The devices are erased (this may take some time).
2. The base system information is transferred, followed by the file data itself.
3. The data progress is displayed by XX% up to 100%. The actual file being sent is also
shown (unless a complete diskette copy is performed). In addition, the elapsed time of
the transfer is displayed.
If an error occurs during transfer, the system beeps twice to warn you.
To signal the end of a successful transfer, a single beep is heard.
F The transfer operation can be time consuming in Serial Mode due to the serial
transfer speed and protocol.
VFLASH Software
11-12
Advertisement
Table of Contents
