Table of Contents
Advertisement
SECTION 3
SETTING JUMPERS
This Section describes how to configure hardware options by setting jumper switches on
the VIPer board.
3.01 TERMINOLOGY
Jumper switches are small pins that you can set by using jumper caps. Two pins can be
joined by a jumper cap, thereby closing or shorting a circuit. So you short (or close) a
jumper by placing a plastic jumper cap over two pins of the jumper switch, and you open
a jumper switch by removing a jumper cap.
3.02 JUMPER LOCATIONS ON THE BOARD
Diagram 3-1 on the next page shows 29 jumpers labeled from W1 to W29. These appear
as rectangular boxes containing small circles which represent the pins. The jumpers are
labeled on the board as well. When there are more than two pins in a jumper, then some
of the pins are also numbered on the diagram and on the board, so that it will be possible
to locate each pin and its number.
Setting Jumpers
3-1
Advertisement
Table of Contents
