Table of Contents
Advertisement
SECTION 13
UPDATING BIOS WITH UBIOS
UBIOS is a utility that allows you to take BIOS files from a disk and update the Flash
BIOS EPROM with them. It also allows the reverse operation - to copy the contents of the
Flash BIOS to files on disk.
The program can be executed in one of two modes:
•
Interactive Mode: In this mode, the program is menu-driven. This mode is explained
in section 13.01.
•
Batch Mode: It is also possible to run the program without menus by a command
which specifies the selected options and files with parameters. This mode is explained
in section 13.02.
Both the Interactive Mode and the Batch Mode are available in VT100 mode (Section 14).
The small differences will be explained in the sections noted above.
Note: Using UBIOS 2.15 and up to update the main BIOS (AMIBIOS), will clear the
CMOS Setup in ROM. Therefore, it is recommended that you take note of
your Setup parameters (especially Hard Disk parameters), so you can reset
them afterwards.
Updating BIOS With UBIOS
13-1
Advertisement
Table of Contents
