Table of Contents
Advertisement
4. When the transfer is 100% complete, the following message is displayed:
Do you want to Reset the receiving system?
This software command is made available to restart the receiving system by remote. In
order for a new Flash disk to be recognized by the BIOS and DOS, the system must be
rebooted.
The receiving system can be put in Download Mode by any of the following options:
1. Short Pins 1 and 2 on jumper W22. This forces Download Mode at boot up.
2. Download Mode is automatically enabled when VT100 Mode is activated by shorting
Pins 3 and 4 on jumper W22. In this case, the communications port will recognize the
Download Mode commands and activate it.
F Reset is the only way to exit from Download Mode which is forced on at setup by
the W22(1-2) jumper. If Download Mode was entered by recognition of the code
sequence, you can simply exit Download Mode and continue processing.
VFLASH Software
11-13
Advertisement
Table of Contents
